| |
Å
Only the highest quality materials are used in the
manufacture of our cutting dies. The specific alloy and hardness
are chosen to correspond precisely with the length of the
production run and material requirements requested by our
customer. All dies are manufactured with an internal and
external geometry that ensures greater resistance to breakage
with increased performance and accuracy.
Å Performance of our "S5"
alloy tool steel is generally between 3 to 5 million labels
before sharpening is required. This statistic is based on coated
paper stock and may vary depending on material and cutting room
conditions. Metalized paper and film can also be cut using this
alloy composition with approximately the same production.
Å Cutting both paper and
plastic this grade of steel has also been found to work with the
new poly and film materials as well as small books under
counter-pressure.
Å Contact our Bolton
Landing N.Y. office for a material recommendation for your
specific requirement. |
Height of label cutting die:
60 mm to 85 mm
Materials: Aluminum base / Steel
crown Steel base
Performance before die sharpening:
Depending on paper quality between 3 to 5 Million labels |
